Remove the two screws at the bottom of the phone with the torx 6 screwdriver.
Next push the slider up so you have access to the metal plate, shown below. Run your finger around the edge where the metal plate meets the housing to unclip it.
With the metal plater removed you have access to two more torx 6 screws. Remove these
Run your fingernail all the way around the edge of the housing to release it
The phone will now be in two parts, as below
The screen assembly is held on by two clips at each side of the phone, indicated below. Unclip them
Unclip the board for the keypad by lifting it from the right side. It attaches to two ribbons like a plug and socket. The screen ribbon is also attached to the back of this board: also detach this.
Your phone should now look like the picture below
Remove the LCD and replace with the new one (if applicable). If you are replacing the LCD only you do not need to go any further than this stage. Reverse what you've just done for reassembly
Remove 4 Phillips screws circled below
Lift the metal plate to allow access to two more torx screws, circled below. Remove the ribbon which is attached to the back of the metal plate (shown held below) to access to rest of the phone. It is held on with double sided tape or glue and simply peels off
Remove the two torx screws circled below then run your finger along the edge of the housing to separate it from the rest of the phone
Slide the ribbon through the housing so you can remove this part of the housing
Remove the circuit board from the back part of the housing. It is held in by clips the run around the edge of the housing so pull the housing outwards in order to release the circuit board
最新Walkman播放器2.0版本简化了在音乐类型、播放列表、歌手歌曲或音乐专辑之间的导航过程,同时具有Gracenote公司 Mobile MusicID(移动音乐身份识别)软件支持的TrackID™(曲目识别)功能,支持MP3、AAC、AAC+、eAAC+、m4a回放,长达30小时的音乐播放时间,具有背景音乐播放